Wolverine ESP 5000 Manual de usuario descargar pdf (Pagina 17)

Ready to view, edit, print or transfer your data to a computer or from the computer to the

ESP, simply connect the ESP’s USB cable (provided) mini jack into the ESP USB port

and the other jack to any computer USB port.

Connect directly to USB ports that are attached to the computer’s motherboard.

Do not use USB ports from hubs, Docking stations or Front USB ports

Turn on the ESP by pressing and holding the power button for 2-3 seconds. At initial

usage the computer system will cycle through installing three new drivers (in windows

XP a message that the hardware is ready for use will appear indicating that the device is

installed and ready).

• In Windows double click on “My Computer”. For Mac. The ESP drives will appear

on the Desktop screen

• Under “My Computer” the ESP will show three new drives as shown below

Please, note that drive letters are assigned by your computer operating system and are

dependent on the next available unused driver letter. Example above shows the

Wolverine labeled as drive (G:) represents the ESP’s internal hard drive and the

Removable drives (E:) and (F:) represent the two built-in memory card slots.

• Double Click on the Wolverine Drive to access the contents of the ESP hard drive

• The ESP hard drive is organized in the following folders structure (NEVER DELETE

THESE FOLDER):

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 29 30

Sin comentarios

Wolverine ESP 5000 Manual de usuario Pagina 17