Wolverine Soffit and Decorative Trim Manual de usuario descargar pdf (Pagina 37)

Window Flashing

The width of all flashings is determined by the type of

accessory surrounding the window and where the final

complete course of siding stops below the window (in the

case of the flashing under the window). The flashing should

extend past the nail flanges of the accessory. The width of the

flashing under the window must allow for the diversion of

water.

*see NOTE below

Apply the vertical flashings by overlapping the previously

secured bottom flashing. As noted above, the length and

width of the flashings will be determined by the type of

accessories used.

Secure top flashing.

NOTE: The flashing is long enough to direct water

over the nail flange of the last course of complete

siding panels.

For even greater protection,

make a slit in the building

wrap and insert the top

flashing behind it. Tape the

seam as shown.

Wolverine Fit and Finish Installation Guide

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 116 117

Sin comentarios

Wolverine Soffit and Decorative Trim Manual de usuario Pagina 37